Changes

<!{|style="float: left;"|{{Language-- table at top of page with logo, picture, Application level, Management level, and input-output tables -->box|english_link=Unplanted_Drying_Beds|french_link=Lits_de_séchage_non_plantés|spanish_link=Lechos_de_Secado_sin_Plantas|hindi_link=coming soon|malayalam_link=coming soon|tamil_link=coming soon | korean_link=coming soon | chinese_link=Coming soon | indonesian_link=Coming soon | japanese_link=Coming soon}}|}{|width="100%"|style="width:50%;"|{{santablesantable_new|

sys2=[[Blackwater Treatment System with Infiltration|56]]|sys3=[[Blackwater Treatment System with SewerageEffluent Transport|67]]|sys4=[[Blackwater Transport to (Semi-) Centralized Treatment System |78]]|sys5=[[Sewerage System with Urine Diversion |89]]|

Input1=Faecal Sludge |Input2= |Input3= | Input4= |Input5=|Output1= Effluent | Output2= Faecal Sludge | Output3= | Output4= | Output5=

'''An Unplanted Drying Bed unplanted drying bed is a simple, permeable bed that, when loaded with sludge, collects percolated leachate and allows the sludge to dry by evaporation. Approximately 50% to 80% of the sludge volume drains off as liquidor evaporates. The sludge , however, is not effectively stabilized or treatedsanitized.'''

<br>The bottom of the drying bed is lined with perforated pipes that to drain the leachate away that percolates through the leachatebed. On top of the pipes are layers of gravel and sand and gravel that support the sludge and allow the liquid to infiltrate and collect in the pipe. The sludge should be loaded to approximately 200kg TS/m2 and it It should not be applied in layers that are too thick (maximum 20cm20 cm), or the sludge will not dry effectively. The final moisture content after 10 to 15 days of drying should be approximately 60%. A splash plate should be used to prevent erosion of the sand layer and to allow the even distribution of the sludge. When the sludge is dried, it must be separated from the sand layer and disposed oftransported for further treatment, end-use or final disposal. The effluent leachate that is collected in the drainage pipes must also be treated properly. The top sand layer should be 25 to 30cm thick as some sand will be lost each time the sludge , depending on where it is manually removeddischarged.

{{procontable | pro=- Can be built Designing unplanted drying beds has to consider future maintenance because ensuring access to people and repaired with locally available materials <br> - Moderate Capital Cost; low operating Cost. <br> - Potential trucks for local job creation pumping in the sludge and income generationremoving the dried sludge is essential. <br> - No electrical energy required. | con=- Requires large land area. <br> - Odours If installed in wet climates, the facility should be covered by a roof and flies are normally noticeable. <br> - Long storage times. <br> - Requires expert design and operation. <br> - Labour intensive removal. <br> - Leachate requires secondary treatmentspecial caution should be given to prevent the inflow of surface runoff.}}

Sludge drying is an effective way of decreasing the volume of sludge<br>{{procontable | pro=- Good dewatering efficiency, which is especially important when it requires transportation elsewhere for direct use, [[Coin dry and hot climates <br>-composting]], or disposal. The technology is not effective at stabilizing the organic fraction or decreasing the pathogenic content.Can be built and repaired with locally available materials <br>- Relatively low capital costs; low operating costs <br>Sludge drying beds are appropriate for small to medium communities with populations up to 100- Simple operation,000 people and there only infrequent attention required <br>- No electrical energy is inexpensive, available space that is far from homes and businesses. It is best suited to rural and periurban areas. If it is designed to service urban areas, it should be on the edge of the community.required| con=The sludge is not hygienized and requires further treatment before disposal. Ideally this technology should be coupled with - Requires a Colarge land area <br>-Composting facility to generate a hygienic product. Trained staff for operation Odours and maintenance is required to ensure proper functioning.flies are normally noticeable <br>- Labour intensive removal <br>This is a low-cost option that can be installed in most hot Limited stabilization and temperate climates. Excessive rain may prevent the sludge from properly settling pathogen reduction <br>- Requires expert design and thickening.construction <br>- Leachate requires further treatment}}

==Health Aspects/Acceptance=Appropriateness=== Sludge drying is an effective way to decrease the volume of sludge, which is especially important when it has to be transported elsewhere for further treatment, end-use or disposal. The technology is not effective at stabilizing the organic fraction or decreasing the pathogenic content. Further storage or treatment (e.g., Co-Composting, T.16) of the dried sludge might be required. Unplanted drying beds are appropriate for small to medium communities with populations up to 100,000 people, but larger ones also exist for huge urban agglomerations.

The incoming sludge They are best suited for rural and peri-urban areas where there is pathogenicinexpensive, available space situated far from homes and businesses. If designed toservice urban areas, so workers unplanted drying beds should be equipped with proper protection (bootsat the border of the community, gloves, and clothing)but within economic reach for Motorized Emptying operators. The thickened sludge This is also infectious, although it is easier to handle a low-cost option that can be installed in most hot and less prone to splashing and sprayingtemperate climates. The pond Excessive rain may cause a nuisance for nearby residents due to bad odours and prevent the presence of flies. Therefore, the pond should be located sufficiently away sludge from urban centresproperly drying.

==MaintenanceHealth Aspects/Acceptance==Both the incoming and dried sludge are pathogenic; therefore, workers should be equipped with proper protection (boots, gloves, and clothing). The dried sludge and effluent are not sanitized and may require further treatment or storage, depending on the desired end-use. The drying bed may cause a nuisance for nearby residents due to bad odours and the presence of flies. Thus, it should be located sufficiently away from residential areas.

The Unplanted Drying Bed should be designed with maintenance in mind; access ===Operation & Maintenance=== Trained staff for humans operation and trucks maintenance is required to pump in the sludge and remove the dried sludge should be taken into considerationensure proper functioning. Dried sludge must can be removed every after 10 to 15 days, but this depends on the climate conditions. Because some sand is lost with every removal of sludge, the top layer must be replaced when it gets thin. The discharge area must be kept clean and the effluent drains should be regularly flushed regularly. Sand must be replaced when the layer gets thin.

* Elizabeth Tilley etHeinss, U. and Koottatep, T.al (20081998). [httphttps://wwwocw.eawagun-ihe.chorg/organisation/abteilungenpluginfile.php/sandec4081/publikationenmod_resource/publications_sespcontent/downloads_sesp1/compendium_highHEINSS%20and%20KOOTTATEP%201998%20Use%20of%20Reed%20Beds%20for%20FS%20Dewatering.pdf Compendium Use of Sanitation Systems and Technologies] ([http://www.eawag.ch/organisation/abteilungen/sandec/publikationen/publications_sesp/downloads_sesp/compendium_low.pdf low res version])Reed Beds for Faecal Sludge Dewatering. Department A Synopsis of Water Reviewed Literature and Sanitation Interim Results of Pilot Investigations with Septage Treatment in Development Countries Bangkok, Thailand]. Eawag ([http://www.sandec.ch/ Department Sandec]) at the Swiss Federal Institute of Aquatic Science , Dübendorf, CH and Technology (Eawag)AIT, Bangkok, TH. (Provides a full overview of sanitation systems.)

* CritesMontangero, RA. and TchobanoglousStrauss, GM. (19982002). Small and Decentralized Wastewater Management Systems[https://www.eawag.ch/fileadmin/Domain1/Abteilungen/sandec/publikationen/EWM/Articles/SN05_FSM.pdf Faecal Sludge Treatment]. WCB and McGrawLecture Notes, UNESCO-HillIHE, New YorkDelft, USANL.

* HeinssStrande, UL., Ronteltap, M. and KoottatepBrdjanovic, TD. (1998Eds.)(2014). [https://www.un-ihe.org/sites/default/files/fsm_book_lr. Use of Reed Beds for pdf Faecal Sludge Dewatering – A Synopsis of Reviewed Literature Management. Systems Approach for Implementation and Interim Results of Pilot Investigations with Septage Treatment in Bangkok, ThailandOperation]. UEEM Program Report, AIT/EAWAGIWA Publishing, DübendorfLondon, SwitzerlandUK. (Comparison Detailed book compiling the current state of knowledge on all aspects related to planted drying beds.FSM)

* MontangeroTchobanoglous, AG., Burton, F. L. and StraussStensel, MH. D. (20022004). Faecal Sludge Wastewater Engineering: Treatmentand Reuse, Metcalf & Eddy, 4th Ed. Lecture Notes, IHE Delft(Internat. Available: wwwEd.sandec).chMcGraw-Hill, New York, US. (Book)

* Tchobanoglous, G., Burton, F.L. and Stensel, H.D. (2003). Wastewater Engineering===Acknowledgements==={{: Treatment and Reuse, 4th Edition. Metcalf & Eddy, New York.Acknowledgements Sanitation}}