Difference between revisions of "水力喷射 — 综述"

From Akvopedia
Jump to: navigation, search
Line 20: Line 20:
 
| valign="top" | - Generally limited to sandy soils. Soft clay will be penetrated only very slowly and coarse gravel and other highly permeable materials (cracks in the formation) cause loss of working water and cannot be drilled. The borehole stays open by water pressure. To prevent collapsing fluid-drilled boreholes must be kept full of water during the entire drilling and well installation process.通常仅限用于沙质土壤。虽然可以穿透软质黏土，但是速度非常慢，而且粗碎石等透水性强的物质（地质构造中的裂隙）会导致钻井用水流失因而无法钻井。由于有水压，探孔保持敞开。为了防止塌陷，液钻探孔在整个钻井和装井过程中必须保持满水状态。<br>
 
| valign="top" | - Generally limited to sandy soils. Soft clay will be penetrated only very slowly and coarse gravel and other highly permeable materials (cracks in the formation) cause loss of working water and cannot be drilled. The borehole stays open by water pressure. To prevent collapsing fluid-drilled boreholes must be kept full of water during the entire drilling and well installation process.通常仅限用于沙质土壤。虽然可以穿透软质黏土，但是速度非常慢，而且粗碎石等透水性强的物质（地质构造中的裂隙）会导致钻井用水流失因而无法钻井。由于有水压，探孔保持敞开。为了防止塌陷，液钻探孔在整个钻井和装井过程中必须保持满水状态。<br>
 
- A large amount of working water needs to be available on the drilling location (several 200 liter drums/hour). The drilling and well installation needs to be done on the same day. Leaving the borehole open during the night has a high risk of collapsing.钻井点需要大量的钻井用水（每小时几桶200升的水）。钻井和装井需要在同一天完成。如果留下探孔敞开过夜很可能有塌陷的风险。<br>
 
- A large amount of working water needs to be available on the drilling location (several 200 liter drums/hour). The drilling and well installation needs to be done on the same day. Leaving the borehole open during the night has a high risk of collapsing.钻井点需要大量的钻井用水（每小时几桶200升的水）。钻井和装井需要在同一天完成。如果留下探孔敞开过夜很可能有塌陷的风险。<br>
−
- The use of large quantities of water, the use of drilling fluids to greater depths and a motor pump make the equipment cost relatively high. 使用大量水、使用钻井液达到更深以及马达泵的运用使设备成本相对高昂。<br>
+
- The use of large quantities of water, the use of drilling fluids to greater depths and a motor pump make the equipment cost relatively high. 使用大量水、利用钻井液达到更深以及运用马达泵使设备成本相对高昂。<br>
 
|}
 
|}
  

Revision as of 03:21, 25 September 2015

Jetting icon.png

Jetting is based on water circulation and water pressure. As opposed to sludging, water is pumped down the drill pipe and the ‘slurry’ (water and cuttings) is transported up the borehole between the drill pipe and the borehole wall. A motor pump is used to achieve an adequate water flow. The drill pipe may simply have an open end, or a drill bit can be added. Partial or full rotation of the drill pipe can be used. Thickeners (additives) can be added to the water in order to prevent hole collapse and reduce loss of working water (drill fluid).水力喷射是基于水循环和水压的一种方法。与生成淤泥相反，水被泵至钻管下方，“泥浆”（水与钻屑）被向上输送至钻管和井壁之间的探孔。运用马达泵来获得适当的水流。钻管可能只有一端有开口，或者可以增加一个钻头。可使用部分或完全转动钻管。可在水中加增稠剂（添加剂），防止洞口塌陷并降低钻井用水（钻井液）的流失。

Jetting is practiced in a wide range of varieties. The most simple consists of driving a plastic pipe down with water pressure from a motor pump (no drill bit and no rotation, with the water flow jetting the sand up). The depth is limited (no drill bit and extendable pipes). Other systems make use of extendable plastic or galvanized pipes and a drill bit and are rotated during drilling. With these systems greater depth can be reached.水力喷射法使用的方式多样。最简易的是利用马达泵制造的水压将塑料管压下（不用钻头或转动，利用水流将沙子喷射上来），但深度有限（无钻头或可伸长的管子）。其它方法利用了可伸长的塑料或电镀管，使用钻头，且在钻井中进行旋转。使用这些方法，可以达到更深的深度。

适宜条件

手动旋转的水力喷射法
典型钻头

Suitable for weakly cohesive sands and silts. Manual jetting is generally used up to depths of 35 meters.适用于粘着力弱的沙和淤泥。手动水力喷射法通常用于最深为35米的深度。


优势 不足
- Very quick in fine and medium sand formations.在细砂或中粒砂的地质构造中，钻井很快。
 - Generally limited to sandy soils. Soft clay will be penetrated only very slowly and coarse gravel and other highly permeable materials (cracks in the formation) cause loss of working water and cannot be drilled. The borehole stays open by water pressure. To prevent collapsing fluid-drilled boreholes must be kept full of water during the entire drilling and well installation process.通常仅限用于沙质土壤。虽然可以穿透软质黏土，但是速度非常慢，而且粗碎石等透水性强的物质（地质构造中的裂隙）会导致钻井用水流失因而无法钻井。由于有水压，探孔保持敞开。为了防止塌陷，液钻探孔在整个钻井和装井过程中必须保持满水状态。

- A large amount of working water needs to be available on the drilling location (several 200 liter drums/hour). The drilling and well installation needs to be done on the same day. Leaving the borehole open during the night has a high risk of collapsing.钻井点需要大量的钻井用水（每小时几桶200升的水）。钻井和装井需要在同一天完成。如果留下探孔敞开过夜很可能有塌陷的风险。
- The use of large quantities of water, the use of drilling fluids to greater depths and a motor pump make the equipment cost relatively high. 使用大量水、利用钻井液达到更深以及运用马达泵使设备成本相对高昂。

建造、运作与维护

Jetting. Credit: WEDC.

All drilling equipment, except the motor pump and some valves, is locally produced.除了马达泵和一些阀门外，所有的钻井设备都由当地生产。

实地经验

水力喷射法主要用于尼日尔、乍得、马达加斯加、尼日利亚、塞内加尔、布基纳法索、乌干达、肯尼亚、苏丹、贝宁、斯里兰卡和一些西方国家。

指南、视频与链接

  • Lifewater Resources on hydrogeology, well construction, all drilling techniques, hand pumps and more. Lifewater Canada, update 2004.
  • Manuals on Percussion drilling, well construction, manufacturing tools. Cliff Missen, Wellspring Africa, draft 4.
  • Lots of articles on Jetting. Rural Water Supply Network.
  • PAT-Drill - Engine powered drilling equipment and small machines.
  • Lone Star Bit - Engine powered drilling equipment and small machines.
  • Deep Rock - Engine powered drilling equipment and small machines.
  • Drillingfab. - Engine powered drilling equipment and small machines.

鸣谢

Retrieved from "https://akvopedia.org/s_wiki/index.php?title=水力喷射_—_综述&oldid=29159"