Difference between revisions of "Sump tank"
(→Construction, operation and maintenance) |
|||
| Line 36: | Line 36: | ||
* Sumps could have level indicators, so that the pumps don’t run dry. Level indicators can be as simple as a dip-stick or can be electronic. Dip-stick systems have the disadvantage of being a conduit for light and impurities to enter the storage tank | * Sumps could have level indicators, so that the pumps don’t run dry. Level indicators can be as simple as a dip-stick or can be electronic. Dip-stick systems have the disadvantage of being a conduit for light and impurities to enter the storage tank | ||
| + | |||
| + | * Cylindrical ferrocement or RCC recommended as tank building material. Plastic or brick is not recommended. | ||
===Bangalore example=== | ===Bangalore example=== | ||
Revision as of 00:36, 29 November 2014
Contents
Suitable conditions
The ground should not be rocky close to the surface, which can hinder the digging and construction process. Secondly the groundwater table in the area should not be very high and should ideally be several metres below the bottom of the tank. Underground sump tanks must not be built very close to underground sewerage chambers or lines trees like the coconut which have strong roots that spread widely existing foundations, especially those that may not be very deep waste water treatment systems.
| Advantages | Disadvantages |
|---|---|
| - Generally cheaper than above ground storage tanks - Water cannot leak out through an open tap |
- Construction is time consuming - Can affect the foundation of the building if constructed very close to the building |
Construction, operation and maintenance
- The overflow pipe should be just below the tank / sump cover so that there is no ‘dead space’ and the tank can be used to its maximum capacity. The overflow pipe should divert the excess water away from the sump and the foundations of other buildings and structures. This water should be directed to gardens or into the storm water drain and should not create slushy areas. A reverse U bend should be installed at the end of the overflow pipe so that light and other impurities do not enter the tank.
- Water should be extracted from the tank / sump only by means of a tap or pump. Taps or draw off pipes should not be very close to the bottom of the tank, since there is likelihood of sedimentation and the dirt should be allowed to settle and remain in the tank until cleaned. If the dirt enters the water outlet pipe and the plumbing network it can cause blockages.
- Sumps could have level indicators, so that the pumps don’t run dry. Level indicators can be as simple as a dip-stick or can be electronic. Dip-stick systems have the disadvantage of being a conduit for light and impurities to enter the storage tank
- Cylindrical ferrocement or RCC recommended as tank building material. Plastic or brick is not recommended.
Bangalore example
In Bangalore, water will be purchased from private water tankers and stored to be used for construction. One estimate says there a million sumps in the city alone with an average capacity of 6000 litres. This means that the water storage capacity created is a staggering 6000 million litres. Remember that the city gets in about 1000 million litres every day. Added to the fact that there is about 1000 million litres stored in overhead tanks the water storage by the city far outstrips that created by the utility.
Once the construction is completed the very same sump tank will be used to store the intermittent supply from the water utility. From here a pump will send it to the overhead tank to be reticulated by gravity to all the water points in the building.
Usually the sump tank is located in the North East corner of the site, especially for those who believe in Vaastu. The overhead tank is located in the South West for that is supposed to be the highest point of a building. Beliefs aside there are many technical things that should be carefully thought through to ensure that the sump delivers efficiently what it is supposed to.
The sump should be based on firm earth and with a good bed concrete. If the soil below is clayey or non-homogeneous it is better to build a RCC raft slab below. The side walls should not be compromised on and should be with good brick work using a nine inch wall. Alternately concrete blocks or hollow concrete blocks of good quality can be used. In high water table areas or areas of loose soil both sides of the wall should be plastered. The inside of the sump tank wall should be plastered with a waterproof compound on a wire mesh base. This will ensure that the sump tank does not leak. After it is built the tank should be filled with water and checked that there is no leak. Any leak should be detected and fixed immediately.
Sump tanks are extremely unsafe spots on a site especially for children of construction workers and for others. They should immediately have a cover slab cast with an inspection cover securely locked. The sump cover should be rust proof. Aluminum covers are now available which are excellent.
The other things to remember are to use a submersible pump which is energy efficient. The submersible pump will save space being inside the sump. The pipeline from the sump to the overhead tank should be as straight as possible and with as few bends as possible. PVC or GI pipes of the right gauge and size should be used.
A ball valve regulates the water intake into the sump. This should be of good quality and should function effectively. In Bangalore the sump can also double up as a rainwater harvesting structure thus being multi-purpose in use. During the rains rainwater and during the non-rainy season water from other sources can be stored.
While digging in most places in the city good red earth will be obtained. This can be used for gardening and even for the making of earth blocks for the building.
An annual cleaning and maintenance is recommended preferably without wasting the water inside it. During summer and during water borne disease outbreaks it is best to dose the sump water with bleaching powder and to measure the residual chlorine as 2 mg per litre after about 4 hours of the dosing. This will keep waterborne infections like cholera at bay.
Even though hidden from view the sump tank has an important role to play in the use of a building. A good design and maintenance will help extend its life and for it to perform optimally. In this understanding lies water wisdom.
The ideal system in Bangalore is one where rainwater is stored in sumps and the surplus used for recharging borewells.
Costs
A tanker load (in Bangalore) of 6000 litres costing about Rs 200/-. To store water during construction, sumps were built and these would also be 6000 litres so as to fill up a tanker load completely. Coincidentally this happened to be the exact optimal storage requirement for rainwater harvesting. This made it easier for implementation using the sump as storage1.
Manuals, videos and links
References
Acknowledgements
- On the sump tanks of Bangalore. October 31, 2013.
