View source for Pre-Treatment Technologies



{|width="100%"
|style="width:50%;"|
{{santable_new|
sys1=[[Single Pit System |1]]|
sys2=[[Blackwater Treatment System with Infiltration | 6]]|
sys3=[[Blackwater Treatment System with Effluent Transport | 7]]|
sys4=[[Blackwater Transport to (Semi-) Centralized Treatment System | 8]]|
sys5=[[Sewerage System with Urine Diversion | 9]]|
sys6=|
sys7=|
sys8=|
sys9=|
pic=pre-treatment technology.png|
ApplHousehold=X|
ApplNeighbourhood=XX|
ApplCity=XX|
ManHousehold=X|
ManShared=X|
ManPublic=XX|
Input1=Blackwater|Input2=Greywater |Input3=Sludge | Input4=Brownwater |Input5=|
Output1= Sludge | Output2=Blackwater | Output3=Brownwater | Output4=Greywater | Output5=Pre-Treatment Products
|english_link=Pre-Treatment Technologies
|french_link=à venir
|spanish_link=próximamente
}}
|[[Image:pre-treatment technology.png|right|400px]]
|}

<br>
----
<br>

'''Pre-treatment is the preliminary removal of wastewater or sludge constituents, such as oil, grease, and various solids (e.g., sand, fibres and trash). Built before a Conveyance or Treatment technology, pre-treatment units can retard the accumulation of solids and minimize subsequent blockages. They can also help reduce abrasion of mechanical parts and extend the life of the sanitation infrastructure.'''


Oil, grease, sand and suspended solids can impair transport and/or treatment efficiency through clogging and wear. Therefore, prevention and early removal of these substances is crucial for the durability of a treatment system. Pre-treatment technologies use physical removal mechanisms, such as screening, flotation, settling and filtration. Behavioural and technical source control measures at the household or building level can reduce pollution loads and keep pre-treatment requirements low. For example, solid waste and cooking oil should be collected separately and not disposed of in sanitation systems. Equipping sinks, showers and the like with appropriate screens, filters and water seals can prevent solids from entering the system. Sewer inspection chambers should always be closed with manhole covers to prevent extraneous material from entering the sewer.