Changes

Percussion - Stone hammer

1 byte added, 20:37, 22 October 2015

no edit summary

[[Image:percussion gouge.jpg|thumb|right|200px|percussion gouge]]

__NOTOC__ <small-title />

The Stone Hammer is a form of [[Percussion - general|percussion drilling]], used when boulders or hard clay is are encountered. A hollow drill bit is attached to a hammering tool. The hammering tool consists of a heavy weight which moves up and down in a pipe. Once the bit and hammering tool are lowered into the borehole by a cable, the same cable can be used to do the hammering. Lifting and dropping the hammer drives the drill bit down. When 60cm has been drilled, the unit is pulled up to the surface to empty the hollow drill bit. The stone hammer is only successful when boulders are encountered, not in homogeneous or solid stone layers, where displacement of the material is not possible.

In Western countries the same principle is used with the percussion gouge. As opposed to the stone hammer, the hammering action of the percussion gouge takes place on ground level. The gouge is electrically driven and used to break hard surface layers (rubble) and to take soil samples.

• ← Older edit
• Newer edit →

Winona

Akvopedia-spade, akvouser, bureaucrat, emailconfirmed, staff, susana-working-group-1, susana-working-group-10, susana-working-group-11, susana-working-group-12, susana-working-group-2, susana-working-group-3, susana-working-group-4, susana-working-group-5, susana-working-group-6, susana-working-group-7, susana-working-group-8, susana-working-group-9, susana-working-group-susana-member, administrator, widget editor

30,949

edits